Let's talk about injection depth...

[macgyver]

..


Macgyver. Which VG are you pinning that makes it akward to reach? it's right on the hip.

I am not a very big guy...5'9 195 sub 10%bf. But my back is probably my most developed part. (I can barely touch any area on my back. I cant imagine what it would be like to be truly big) Reaching around to my hip and turning my wrist to make the injection is a little tough to find a good comfortable spot to do it where I can hold steady.

Prior to making my little depth stop, as I would push the plunger in, I would have a tendency to move the needle around. Now I can just bury it till it rests against the skin and I get zero bleeding on pullout and have not had any PIP in ages. (used to get it quite often).

 

[RAIDEN]

Been using 30g x 1/2" slin pins on triceps and recently delts with no issues. Drawing up 1ml of test cyp300 takes about 5 mins but I dont mind. If you have a lower bf percentage, you wont have no issues. My doctor fucked up and wrote my script for needles at 31g x 5/16...I will use them if I have to.

 

[Risen_1]

I've never heard of using slin pins for oil base . Must have plenty of spare time- it would take forever to unload. I use 22g 1.5" for Glutes and 25g 1" for quads and shoulders.

 

[prime]

Unloading time is virtually the same due to barrel diameter and higher pressure.

 

[DF]

Wow, some of you drawing with the slin pin. I just back fill them with a 20g. I've been on trt for about 1 1/2 years. Doing all that pinning you look to change things up a bit. I've used slin pins for delt & quad injects w/o a problem. As others have said I'd be a bit concerned on a longer slin pin. They can bend pretty easy & I'm not sure how much it would take to snap one off in the muscle.

 

[RedNeck]

I typically use a 1ml syringe and 28x1. If going for larger volumes 3ml 25x1.

Used to use 25x1.5" but pulled out to many that were bent. I only pin quads now so the 28g is helping to reduce the scar tissue build up.

 

[YAMAHA147]

25g 1 inch for everything. Only place I dont pin is glutes and bi's

 

[Bionixx]

Damn I use DB 23G1 for everything. I buy the syringes and needles seperate. 25G1 sometimes cause the plunger to bend if you use the same syringe too much. I think 25G are just alittle to small. Just depends on how many shots you need to get out of the syringe.

 

[premo]

23 Guage 1" for me, glutes, hams and delts all 1"

 

[Times Roman]

I use a 1.5" needle. just slap the quad, pound that fucking needle in there, and once you hit bone, just back it off a bit and pump that oil in there.

This is how men do it!!!!

Aaaargh!

 

[regular]

This well referenced injection techniques guide has served me well. It's creation was sponsored by BD. It's a continuing education guide for nurses.

http://filesmelt.com/dl/Safe_injection_techniques.pdf

 

[camthman]

Why arent you just backloading the syringe? takes two seconds.

Been using 30g x 1/2" slin pins on triceps and recently delts with no issues. Drawing up 1ml of test cyp300 takes about 5 mins but I dont mind. If you have a lower bf percentage, you wont have no issues. My doctor fucked up and wrote my script for needles at 31g x 5/16...I will use them if I have to.