Heating Temp Of Masteron

[KBD]

Been searching all over forums, and there is never a straight up answer so I will ask myself. I got some masteron 200mg/ml Prop it crystalized as i expected it to. I heated up in the oven 200 degrees F for 5-7 mins, bottle was very hot. Is this temperature enough to degrade the solution? Still unsure with heating. Anywho there are still 2 crystal flakes floating around, if the solution is crashed at that amount if i still inject am i getting the substance still? Or is it less or does crashing cause a problem at all?

 

[Get Some]

Please tell me you vented the stopper with a needle...

 

[KBD]

Yes I did, well these little 2 flakes arent going away by heating. Is it still legit? If i were to inject would i still be getting some masteron or should i just throw it away?

 

[texastea]

Filter to another vial.

 

[hoodlum]

yes you will still be getting some masteron, yes you should throw it away. if its not brewed properly dont put it in your body

 

[FlyingDragon]

A few flakes represent maybe 1% of the compound, so u still have 99% of the compound in solution. Try boiling a pan of water, toss in the vial and let sit for no more than 5 minutes, all the crystals will b gone.....

 

[Get Some]

200 mg/ml is high for prop, may have to do this each time you inject. I'd just get standard 100mg/ml and use that

 

[BLTC]

shake the hell out of it after heating

 

[shortz]

I have found that slightly lower temps over longer periods of time tends to be safer. I have destroyed a couple bottles of test that crystalized. The bottom of the bottle was touching the bottom of the pot, and must have been absorbing a tremendous amount of heat and pretty much burned the solution at the bottom.