Pre-loading syringes

[CFM]

You do any and all compounds subq?

Mind you, I am dosing for TRT. 120mgs/week is a blast. Divide 3.5 injections/ week by a 200mg compound and the oil volume is minimal. Yes all compounds except suspension, also D and U esters as they are extremely long, those do not metabolize quickly from the site causing welts, but that is me.

 

[trentracks]

Funny timing on this post I just made 4 of them for tomorrow

 

[Lil Ed]

That's what I do!

I will preload my slin pins for about a week, but I will place them where the needle is downward so that there is a small air bubble near the plunger. I can't say they always stay in this position 100% of the time, but I try, lol. I have them sealed in a plastic sandwich bag in a cool dark area too

Everyone is on the move. I assume trying to save time pre loading for weeks in advance.

I had no idea this practice was so popular, . very Low solvent % oils makes allot more sense for this practice. .09% BA is a no no. some HG has allot of BB... just insane.

 

[Puff88]

Appreciate all the feedback!

 

[Glycomann]

Sterility isn’t an issue but some solvents used in gear will eat up the plungers of your syringes.

That's it right there. I do it on Monday and the last one gets used on Friday but I am probably injecting plasticizers.. not good. But when I am using Test P for my TRT I like to back load 3 pins at a time. Probably gear with less solvent like Test E would be better since at least some pharmas only use an oil and 2% BA. UGL is anyone's guess what gasoline is in it.

 

[Glycomann]

Could consider leaving a vapor barrier between the gear and the plunger. That would keep the solvent from degrading the plunger.