jhotsauce7
TID Board Of Directors
- Jan 18, 2011
- 2,805
- 684
Where did the rule of thumb of approx mw of 200 or less should be used with a dermal application....is this bro science? I found the following post on another board re: npp dermals
*b182, on Nov 10 2006, 06:46 PM, said:
Are 4AD-EC and nandrolone phenylpropionate of a low enough molecular weight that they could make effective transdermals?
go here and type in any drug or compound and you will see the MW as well as other info
http://chem.sis.nlm....gov/chemidplus/
as I recal 4-AD is around 300 dalton
you will have to check the others. Anything in the 400 dalton range is fine. According to Dr; Rogers of JAR Pharma you can use up to 700 dalton in a transdermal. i interviewed him on my radio show. the episode was too scientific for most but chock full of good info for the TD lover out there.
*b182, on Nov 10 2006, 06:46 PM, said:
Are 4AD-EC and nandrolone phenylpropionate of a low enough molecular weight that they could make effective transdermals?
go here and type in any drug or compound and you will see the MW as well as other info
http://chem.sis.nlm....gov/chemidplus/
as I recal 4-AD is around 300 dalton
you will have to check the others. Anything in the 400 dalton range is fine. According to Dr; Rogers of JAR Pharma you can use up to 700 dalton in a transdermal. i interviewed him on my radio show. the episode was too scientific for most but chock full of good info for the TD lover out there.