you need a sterile vial to put it in for storage. they sell plain empty sterile vials in just about any size you want.
depending on the size of your bac water you can always use that container as well. draw out any extra that you dont need. then take 1 cc and mix with amp and draw back out and inject into the bac water bottle.
If the kit you have came with 1 amp of water and 1 amp of powder or compressed powder then just break both amps and combine. Depending on the dose you want to take you may need to store the rest either in a vial or pre-load some pins and put them in the fridge.
You will need a steril vial and a sterile syringe of your choice
1) Draw 1cc Bac water into a syringe 2) Break amp 3) Slowly dispense the Bac water from step 1 into the portion of the amp containing the lypholyzed powder 4) Allow powder to dissolve 5) Using same syringe, draw new mixture out of the amp 6) Slowly dispense the mixture into your sterile vial 7) Take same syringe and draw another 1cc of bac water 8) Slowly dispense Bac water into portion of the amp that you just drew from(think of this as a rinse) 9) Draw fluid back out of the amp 10) Slowly dispense fluid into your vial containing the previous 1cc mixture.
You should now have a sterile vial containg 2cc of reconstituted HCG mixture. Provided your HCG kit was 5000iu, your mixture will be 250iu per 1/10th cc(10clicks on a slin pin). Keep this new mixture refrigrated.
Very good info here. Im about ready to mix my hcg but I have a little different scenario here. Hoping you can help. I have a vial containing 5000iu of hcg freeze dried. The kit provided an amp of 1ml of sodium chloride injection. Should I use this plus 1 ml of bac water? Can I use just bac water? And my pack says for intramuscular injection only. From what ive read and researched here it seems that I dont need to use intramuscular even if it says that? Thanks