liquid Oral Steroid Recipes

Discussion in 'Chemical Conversion Discussion' started by guss, Jul 26, 2011.

  1. guss

    guss MuscleHead

    Aug 11, 2010
    388
    175
    Grabbed this from another website. Enjoy.

    Homebrew sure is fun if you ask me. I remember my first conversion. It was Nolvadex 20mg/ml. It was clear as water in 190 proof grain alcohol after some heat. Then two days later it crashed and I felt so let down. I followed the formulas out there and it wasn't working out. So I dug deeper and learned about PEG's and molecular weights and the such. I have made almost every conversion their is in the homebrew realm and would like to share my liquid oral recipes with the anabolic world.

    For each hormone I listed ingredients needed. For the procedure scroll down.

    anadrol:
    Highest concentration made - 50mg/ml
    Per 1 gram of Oxymetholone you will need:
    8.4 ml's of PEG 300
    10.5 ml's 190 Proof Grain Alcohol

    anavar:
    Highest concentration made - 20mg/ml
    Per 1 gram of Oxandrolone powder you will need:
    9.8 ml's of PEG 300
    39.2 ml's of 190 Proof Grain Alcohol

    Armidex:
    Highest concentration made - 5mg/ml
    Per 1 gram of Anastrozole powder you will need:
    19.9 ml's PEG 300
    179.1 ml's of 190 Proof Grain Alcohol

    Clomid:
    Highest concentration made - 50mg/ml
    Per 1 gram of Clomiphene Citrate you will need:
    8.4 ml's of PEG 600
    10.5 ml's 190 Proof Grain Alcohol

    dianabol:
    Highest concentration made - 50mg/ml
    Per 1 gram of Methandrostenolone powder you will need:
    19 ml's of 190 Proof Grain Alcohol
    No PEG needed. Follow the no PEG recipe.

    Femara:
    Highest concentration made - 5mg/ml
    Per 1 gram of Letrozole powder you will need:
    19.9 ml's PEG 300
    179.1 ml's of 190 Proof Grain Alcohol

    Nolvadex:
    Highest concentration made - 20mg/ml
    Per 1 gram of Tamoxifen Citrate you will need:
    9.8 ml's of PEG 600
    39.2 ml's of 190 Proof Grain Alcohol

    Proviron:
    Highest concentration made - 50mg/ml
    Per 1 gram of Mesterolone you will need:
    8.4 ml's of PEG 300
    10.5 ml's 190 Proof Grain Alcohol

    winstrol:
    Highest concentration made - 25 mg/ml
    Per 1 gram of Stanzolol you will need:
    7.8 ml's of PEG 300
    31.2 ml's of 190 Proof Grain Alcohol


    ---------------------------------------------------------------------------------

    Solutions requiring PEG and 190 Proof Alcohol

    Step 1. Prepare a hot water bath. Boil water in microwave or on a pot. Once boiling starts remove from heat.

    Step 2. Place PEG and powder in beaker.

    Step 3. Place the beaker deep enough in to the water so that the hot water is level with the PEG and powder. Gently swirl or stir with a stir rod until solution is clear. Reheat water as needed.

    Step 4. Allow PEG to cool some. Then add in your 190 proof alcohol. You don't have to do this drop by drop but don't just dump it in. Pour it in slowly.

    Step 5. Stir or gently shake until mixed.


    For recipes that do not require PEG.

    1. Mix powder and 190 proof alcohol.

    2. Stir with stir rod or shake. Most powders that do not require PEG will disolve no problem. If heat is needed follow the instructions for heating powders that use PEG.
     
  2. Spectrum

    Spectrum Senior Member

    Dec 16, 2010
    101
    18
    I'm a recovering addict/alcoholic so alcohol at any amount is out of the question for me. I've been using a product designed for use by compounding pharmacies and have for years.
    Used to be 2 products = ora-plus and ora-sweet. The sweet is mainly for adding flavor. They've combined the 2 into one product now I think - ora-blend I believe its called. Google em if you want more info. These do NOT create a solution (where everything dissolves and stays dissolved) but a "suspension". I always micronize any powders as much as possible before compounding. Shake well before each use and its all good......the stuff tastes good and includes preservatives, anti foaming agents, etc.. and should increase the shelf life of your orals.
     
    PillarofBalance likes this.
  3. FlyingDragon

    FlyingDragon VIP Member

    Nov 4, 2010
    2,712
    1,152
    Ora-blend is pretty expensive and I do not believe many UGL would use this item due to the cost factor. If your making up your own goodies, this product would be worth the extra $$$...




     
  4. Regulator

    Regulator VIP Member

    Jan 26, 2011
    2,037
    316
    Nice post! Makes me wanna go cook.
     
  5. basskiller

    basskiller TID Board Of Directors

    Sep 12, 2010
    892
    289
    well normally it's cut with other things such as glycerine and alcohol, which while Spectrum can't use, does make it cost effective.
     
  6. ICE

    ICE Member

    Nov 4, 2011
    21
    0
    I always mixed my raw oral powder with 50/50 snow cone syrup and vodka. The vodka preserves it and a little bit of snow cone syrup from the grocery store makes it taste somewhat better. You just need to shake it up before dosing but works the same without a lot of hassle with high heat and bothering with peg and everclear.
     
  7. overwatch

    overwatch MuscleHead

    Jun 27, 2011
    425
    43
    Vodka and snowcones?! Sounds like a party!
     
  8. YAMAHA147

    YAMAHA147 MuscleHead

    Feb 23, 2012
    1,093
    88
    interesting idea man
     
  9. ruffino

    ruffino Member

    Feb 13, 2012
    85
    5
    Lets get it started.
     
  10. ErikBush

    ErikBush New Member

    Apr 30, 2012
    1
    0
    Cost?

    How much it cost to make this??
     
  11. ritch

    ritch MuscleHead

    Dec 4, 2011
    869
    93
    First... You need a powder source, judging by the question you asked, I'm guessing you don't have one.
     
  12. tommyguns2

    tommyguns2 Senior Moderators Staff Member

    Dec 25, 2010
    3,944
    1,337
    Do you take into account powder displcement the same way we do when brewing oil injectibles?
     

Share This Page